Description
Tesla Model 3 rear axle drive shaft
FEBI Bilstein 186068 is a complete drive shaft for the rear axle of the Tesla Model 3. The same shaft fits on both the left and right sides of the car.
The drive shaft transfers the power generated by the rear drive unit to the rear wheel. The assembly includes the axle as well as the drive and wheel units with the drive belts and protective rubber seals.
Description
- Product: complete rear axle drive shaft
- Manufacturer: FEBI Bilstein
- Manufacturer's product number: 186068
- GTIN/EAN: 4054224860687
- Tesla spare part numbers provided by the manufacturer:
- 1044161-00-D
- 1044164-00-A
- Installation location: rear axle
- Fitting side: left or right
- Mounting position: rear, right and left
- Compressed minimum length: 809 mm
- Wheel-side external injury: 30
- External damage to the propulsion unit: 29
- Ring size: M24 × 1.5
- Weight with packaging: about 7.1 kg
- Package contents: one complete drive shaft
Steering shaft rear right and left FEBI BILSTEIN, Tesla Model 3
Installation
Lift and support the vehicle, remove the rear wheel and open the attachment points of the drive axle according to the Tesla service manual. Replace the drive axle configuration of the rear axle and install the new disposable attachments, then tighten them according to the instructions. The linked instruction shows the left side; on the right side, the same procedure is followed.
- Model 3, rear-wheel drive (as shown in the instructions: left side): Check the detailed installation instructions on the page Tesla..








Reviews
There are no reviews yet.